The MakersCONTROLLER works in combination with the MakersDRIVER (5Up Pro, 2Up Pro) to create sunrise, sunset and other special effects throughout the day.
Features:
• Works exclusively with the MakersLED MakersDRIVER PRO series (5Up Pro, 2Up Pro)
• Simulates sunrise, sunlight, sunset, and moonlight
• Up to 5 Channels of Independent Control
– Up to 4 Channels when used with 2 MakersDRIVER 2UP Pro drivers
– 5 Channels when used with the MakersDRIVER 5UP Pro
• Special effects include lunar cycle, noon peak, storms with lightning, and cloud cover
• Provides a single remote control point to a virtually unlimited number of MakersDRIVERs*
• Demo/Preview mode provides a means to quickly scroll through every minute of the day
• Installation is as simple as plugging in a single cable into the MakersDRIVER
– Powered from the MakersDRIVER – requires no external power source or additional cables
• Integrated clips to mount to the side of the MakersLED heatsink
• Integrated screw tabs for wall mounting and hanging
• Simple programming & menu structure
• Simulates sunrise, sunlight, sunset, and moonlight
• Up to 5 Channels of Independent Control
– Up to 4 Channels when used with 2 MakersDRIVER 2UP Pro drivers
– 5 Channels when used with the MakersDRIVER 5UP Pro
• Special effects include lunar cycle, noon peak, storms with lightning, and cloud cover
• Provides a single remote control point to a virtually unlimited number of MakersDRIVERs*
• Demo/Preview mode provides a means to quickly scroll through every minute of the day
• Installation is as simple as plugging in a single cable into the MakersDRIVER
– Powered from the MakersDRIVER – requires no external power source or additional cables
• Integrated clips to mount to the side of the MakersLED heatsink
• Integrated screw tabs for wall mounting and hanging
• Simple programming & menu structure
Included:
One MakersCONTROLLER with integrated 10ft Cable
Two 3.5mm 18in Data Cables (for daisy chaining multiple MakersDRIVERs)
One MakersCONTROLLER with integrated 10ft Cable
Two 3.5mm 18in Data Cables (for daisy chaining multiple MakersDRIVERs)
Not Included:
MakersDRIVER, Power Supply, Wall Mounting Hardware*Each MakersDRIVER acts as an active signal repeater. The MakersCONTROLLER has been tested with 21 MakersDRIVERs using 1.5ft and 24ft cables cables.
MakersDRIVER, Power Supply, Wall Mounting Hardware*Each MakersDRIVER acts as an active signal repeater. The MakersCONTROLLER has been tested with 21 MakersDRIVERs using 1.5ft and 24ft cables cables.
it would be nice if there were multiple modes, for example when in main menu, short click scrolls through modes such as normal/manual/day/night/preview and then long press goes to the settings, that way there is an easy way to turn the lights on to day or night brightness to demonstrate or show off the aquarium at a time of day when the lights are normally off